Note that you may need to unmount the volume once in a while during the next steps as I found OSX would automatically remount it at random. Open Disk Utility and 'Unmount' the volume.In this particular case the s1 part represents a partition (slice) on the raw device, so the part we'll use later is just the /dev/disk2 part. In my case the 'NO NAME' volume is the SD card, so I take note of the /dev/disk2s1 part. dev/disk2s1 on /Volumes/NO NAME (msdos, local, nodev, nosuid, noowners)` Map auto_home on /home (autofs, automounted, nobrowse) Map -hosts on /net (autofs, nosuid, automounted, nobrowse) You'll see output identifying the mounted volume from your SD card. Identify the raw disk block device on your host system This will lead to severe data corruption.Īs a quick guide these are the steps to attach the device to a linux VM: Most importantly, do not attempt to boot the partition with the currently running host operating system in a guest. Incorrect use or use of an outdated configuration can lead to total loss of data on the physical disk. Warning - Raw hard disk access is for expert users only. Full documentation is in the Advanced Storage Configuration section of the VirtualBox documentation. Because of this you'll need to attach the raw device to the VM in order to gain raw access to the whole card. Please do leave your queries or comments in the comment box below.On newer MacBook Pro's the SD card slot is no longer exposed as a USB device. After the package has been installed, start the virtualbox from menu or from the terminal. Replace virtualbox-5.1_5.1.28-117968~Ubuntu~xenial_b with the package name that you have downloaded. Or you can also get the latest deb packages from Official VirtualBox Page. Once you have the right package install it using dpkg, VirtualBox is available with the default repositories on Ubuntu 16.04 & can be installed using the command, ( Also Read : Managing KVM based Virtual machines : Using CLI ) These should resolve any problem that you might be facing with kernel on VirtuaBox. KERN_DIR=/usr/src/kernels/`uname -r`-`uname -m` Run the following command to set the 'KERN_DIR' variable on the system, Important Note:- We might need to setup the 'KERN_DIR' variable.

How to use virtualbox ubunut